====== GP2X Hardware ======

===== Boot Log =====

  U-Boot 1.0.0 (Sep 10 2007 - 21:07:23)
  
  U-Boot code: 03E00000 -> 03E49FA4  BSS: -> 03E82B70
  IRQ Stack: 03ea3b6c
  FIQ Stack: 03ea4b6c
  DRAM Configuration:
  Bank #0: 00100000 63 MB
  Flash:  0 kB
  NAND:Probing at 0x9c000000
  Flash chip found:
         Manufacturer ID: 0xEC, Chip ID: 0x76 (Samsung K9F1208 64Mb)
  1 flash chips found. Total nand_chip size: 64 MB
  Get Environment from NAND offset 0x70000 ... 
  *** Warning - bad CRC, using default environment
  
  In:    serial
  Out:   serial
  Err:   serial
  
  NAND read: device 0 offset 0x1a0000, size 0x40000 ...  262144 bytes read: OK
  
  NAND read: device 0 offset 0x80000, size 0xb0000 ...  720896 bytes read: OK
  ### main_loop: bootcmd="bootm"
  Hit any key to stop autoboot:  0 
  ## Booting image at 01000000 ...
     Image Name:   GP2X Linux Kernel
     Created:      2007-10-08   9:22:48 UTC
     Image Type:   ARM Linux Kernel Image (gzip compressed)
     Data Size:    673304 Bytes = 657.5 kB
     Load Address: 00008000
     Entry Point:  00008000
     Verifying Checksum ... OK
     Uncompressing Kernel Image ... OK
  
  Starting kernel ...
  
   INIT:  version 2.84 booting 
  <7>**>>ecc error unfixed on chunk 3268:0
   Started device management daemon v1.3.25 for /dev
  <7>**>>ecc error unfixed on chunk 3844:0
  Touch driver open
  Touch calibration
  Apply LCD Timing
  ****nStatus : -1
  
  
  read pointercal value
  write pointercal value
  ****nStatus : 1
  
  
===== SD Card Insertion =====


  MMC/SD Card Detected
  Partition check:
   mmcsda: p1
  Register SD: 1964MsB
  mount...1 
  MSDOS FS: IO charset utf8
  mount...2: